Roland VC-1 D-50 Recording Equipment User Manual


 
25
Applying Effects to the Sound
The relative pitch of the Upper and the Lower Tones can be separately set. By setting slightly different
pitches, a detune effect can be obtained. Also, by lowering the pitch of the Upper Tone, and raising the
pitch of the Lower Tone, the pitches of the Two Tones can become exactly the same.
fig.05-18(LCD_PatchEditControl/Tone)
LKey (Key Shift of the Lower Tone)
Allows you to shift the pitch of the Lower Tone in semi-tone
steps.
Value:
-24–+24 (+/- 2 octave)
UKey (Key Shift of the Upper Tone)
Allows you to shift the pitch of the Upper Tone in semi-tone
steps.
Value:
-24–+24 (+/- 2 octave)
LTune (Fine Tuning of the Lower Tone)
Allows you to Tune the pitch of the Lower Tone.
Value:
-50–+50 (approx. +/- 2 cents)
UTune (Fine Tuning of the Upper Tone)
Allows you to Tune the pitch of the Upper Tone.
Value:
-50–+50 (approx. +/- 2 cents)
You can change the setting of the MIDI Functions included Patch Factor as follows.
fig.05-19(LCD_PatchEditControl/Midi)
TxCH (Transmit Channel)
The transmit channel of each Patch can be set to a deferent
number from the basic channel. At B, the channel number is the
same as the Basic Channel.
Value:
B, 1–16
TxPC (Transmit Program Change Number)
A Program Change number to be transmitted can be set for each
patch individually. At OFF, the Program Change number
preprogrammed in each Patch is transmitted.
Value:
OFF, 1–100
TxBS (Transmit Bank Select Switch)
A Bank Select number MSB to be transmitted can be set for each patch individually (LSB = 0). At OFF, the
Bank Select number preprogrammed in each Patch is transmitted.
Value:
OFF, 0–99
SepCH (Receive Channel in Separate Mode)
A receive MIDI Channel in separate mode can be set for each Patch individually. At OFF, the receive
channel set in MIDI Functions commonly set for System Function is used. (p. 73)
Value:
OFF, 1–16
TONE TUNE
MIDI
vc1_for_XT_e1 25 ページ 2005年3月8日 火曜日 午後12時55分