Filter
Top Products
33
Transferring Patches To and From the D-50/550
Using the D-50
1.
Use a MIDI cable to connect the V-Synth XT’s
MIDI OUT
connector to the D-50’s
MIDI IN
connector.
2.
Set the D-50 and V-Synth XT to the same MIDI channel (the basic channel; p. 73).
3.
Turn the
Memory Protect
of the D-50 to
OFF
.
3-1.
Press the
[TUNE/FUNCTION]
button.
3-2.
Select “
Protect
” with the
Selector button
and turn it
OFF
with the joystick.
4.
Enable reception of bulk load data on the D-50.
4-1.
Press the D-50’s
[DATA TRANSFER]
button.
4-2.
While pressing the D-50’s
[DATA TRANSFER]
button, specify
(B.Load)
with the
Selector
button
.
4-3.
Press the D-50’s
ENTER]
button.
fig.04-05a
5.
Turn the
Exclusive Sw
of the V-Synth XT to
On
.
5-1.
Press
[MODE]
.
5-2.
Touch
<SYSTEM>
.
5-3.
Select “
Exclusive Sw
,” then turn the V-Synth XT’s
VALUE
dial
to specify
On
.
6.
Press
[MODE]
on the V-Synth XT. The
MODE MENU
window
appears.
7.
Touch
<DATA TRANSFER>
. The
DATA TRANSFER
screen
appears.
fig.04-06(LCD_DataTrans_BulkDump)
8.
Touch
<B.Dump>
in the left of the screen. The
MIDI Bulk Dump
screen appears.
9.
Modify the value by either turning the
VALUE dial
or pressing
[INC/+]
or
[DEC/-]
.
Source Bank
Selects the Patch Bank in the VC-1 with the patch data to transfer
to the D-50.
Value:
I1 – I8, P1 – P6
10.
Touch
<OK>
. The bulk dump starts. If you want to cancel without
executing, touch
<Cancel>
.
11.
When the data transfer is completed, the D-50’s display shows “
Complete
.”
12.
Press the
[EXIT]
button on the D-50 to return to the play mode.
Transferring Patches from the VC-1 to the D-50/550
123-1 4-34-1, 4-23-2
vc1_for_XT_e1 33 ページ ２００５年３月８日 火曜日 午後１２時５５分