Filter
Top Products
31
Transferring Patches To and From the D-50/550
* You cannot bulk load data when a patch in the Preset Banks (Pre1 – Pre6) is selected.
* The VC-1 display does not change immediately following the bulk load. This is due to the fact that the work area is
the bulk load destination (p. 37). You can confirm the outcome of the transfer by switching patches with the
VALUE
dial
.
Using the D-50
1.
Use a MIDI cable to connect the D-50’s
MIDI OUT
connector to the V-Synth XT’s
MIDI IN
connector.
2.
Set the D-50 and V-Synth XT to the same MIDI channel (the basic channel; p. 73).
3.
Press the D-50’s
[DATA TRANSFER]
button.
4.
While pressing the D-50’s
[DATA TRANSFER]
button, specify “
B.Dump
” with the
Selector button
.
5.
Press the D-50’s
[ENTER]
button to begin the bulk dump. When the data transfer is completed, the D-50’s
display shows “
Complete
.”
6.
Press the
[EXIT]
button on the D-50 to return to the play mode.
Using the D-550
1.
Use a MIDI cable to connect the D-550’s
MIDI OUT
connector to the V-Synth XT’s
MIDI IN
connector.
2.
Set the D-550 and V-Synth XT to the same MIDI channel (the basic channel; p. 73).
3.
Press the D-550’s
[DATA TRANS]
button.
4.
Select “
(B.Dump)
” with the D-550’s
[]
or
[]
buttons.
5.
Hold down the
[DATA TRANS]
button and press the D-550’s
[ENTER]
button to begin the bulk dump.
When the data transfer is completed, the D-550’s display shows “
Complete
.”
6.
Press the
[EXIT]
button on the D-550 to return to the play mode.
Transferring Patches from the D-50/550 to the VC-1
6 53, 4
5 3, 56
4
vc1_for_XT_e1 31 ページ ２００５年３月８日 火曜日 午後１２時５５分