Filter
Top Products
53
Tone Parameters
* The maximum variable range of each level will depend on the Velocity Range in P-ENV. (p. 51)
Pitch Mod (Pitch Modulation)
Depending on how the LFO in WG modulation (p. 60) is set, the vibrato set here may have no effect at all.
fig.09-14(LCD_P-ENV/PitchMod)
LFOD (LFO Depth)
Sets the depth of LFO-1, that controls the WG pitch. Higher values
deepen the effect.
Value:
0–100
Lever (Pitch Lever Modulation)
Sets the sensitivity of the vibrato depth controlled by the bender
lever. Higher values deepen the effect.
Value:
0–100
After (Pitch Aftertouch Modulation)
This sets the sensitivity of the vibrato depth controlled by
aftertouch. Higher values deepen the vibrato effect.
Value:
0–100
The parameters of LFO-2 and LFO-3 can be set like LFO-1, except for a few parameters.
fig.09-15(LCD_LFO)
Wave (LFO Waveform)
Selects the waveform of the LFO.
Value:
TRI, SAW, SQU, RND
Rate (LFO Rate)
Sets the rate (frequency) of the LFO. Higher values quicken the rate.
Value:
0–100
Velocity Range Level Range
0
+50 +1 octave
-50 -1 octave
1
+50 +1.5 octave
-50 -1.5 octave
2
+50 +2 octave
-50 -2 octave
LFO (Low Frequency Oscillator)
Display Waveform
TRI
(Triangle)
SAW
(Sawtooth)
SQU
(Square)
RND
(Random)
Waveform changes randomly.
vc1_for_XT_e1 53 ページ ２００５年３月８日 火曜日 午後１２時５５分