Filter
Top Products
44
Creating a Patch
The VC-1 provides numerous ways in which you can edit your own patches more conveniently.
To edit a value, you can use the
VALUE dial
,
[INC/+]
or
[DEC/-]
.In each VC-1 screen, you can select a
value using the cursor as described earlier, and modify its value. Each parameter has its own range of
possible values. You
CANNOT
set any value smaller than the minimum value or greater than the
maximum value.
fig.08-03(ValueDial,etc)
Cursor Buttons
Press
[]
,
[]
,
[]
, or
[]
(the cursor buttons) to move the cursor.
VALUE dial
• Turning the
VALUE dial
clockwise increases the value, and turning it counterclockwise decreases its
value.
• Hold down
[SHIFT]
as you move the
VALUE dial
to increase value increments to make large value
changes more quickly.
[INC/+] and [DEC/-]
• Press
[INC/+]
to increase the selected value, and
[DEC/-]
to decrease it.
• Keep the button pressed for continuous adjustment.
• For faster value increases, keep
[INC/+]
pressed down and press
[DEC/-]
. To decrease values quickly, keep
[DEC/-]
pressed down and press
[INC/+]
.
• Hold down
[SHIFT]
while using
[INC/+]
or
[DEC/-]
, the value will change in larger steps.
The
Undo
function returns the current value of the parameter to the original value before being edited.
This only refers to the last parameter that has been adjusted.
fig.08-04(LCD_pulldown_undo)
1.
In the upper right of the screen, touch
<>
. A pulldown menu
appears.
2.
In the pulldown menu, touch
<UNDO>
.
Useful Functions for Editing
Editing a Value
Undoing an editing Operation
vc1_for_XT_e1 44 ページ ２００５年３月８日 火曜日 午後１２時５５分