Filter
Top Products
25
Playing sounds
Playing sounds
Practicing while recording (Rehearsal)
Here’s how you can temporarily stop recording while you’re in the process of recording a phrase.
1
While recording, press the REC button.
The REC button begins blinking. While it is blinking, your
performance is not recorded.
2
Press the REC button once again.
The REC button lights, and recording resumes.
Erasing a recorded note (Erase)
Here’s how you can erase a note from the phrase you’re recording.
1
While recording, press the CANCEL button at the location of the
note(s) you want to erase.
All previously recorded notes are erased from the region for which you
continue to hold down the CANCEL button.
2
When you reach the end of the region from which you want to erase
notes, take your finger off of the CANCEL button.
Normal recording resumes.
The phrase you recorded will be lost if you switch off the SH-201’s power or select a different phrase.
Once you’ve created a phrase you like, you can save it as follows.
1
Hold down the REC button and press the WRITE button.
The indicator of the NUMBER button for the currently selected phrase begins blinking in red, while the indicators
of the other seven NUMBER buttons light in green. The WRITE button’s indicator will also blink.
2
Press the NUMBER button of the phrase number in which you want to save your recorded phrase.
The indicator of the NUMBER button you pressed begins blinking in red, and the indicator that was previously
blinking now lights in green.
3
Press the WRITE button.
The phrase will be saved. (The NUMBER buttons will revert to their usual role of selecting patches.)
* If you decide to cancel this operation, press the CANCEL button at any point before you press the WRITE button in step 3.
Saving a recorded phrase
You can choose the type of data that will be recorded or erased by pressing one of the BANK buttons (A–D)
during the REC standby state or while recording a phrase.
• A (All): All of the following (B, C, D) listed below (Default state)
•
B (Bender): Pitch bender lever operations only
•
C (Controller):
Knob operations (only parameters in the table on p. 72)
• D (notes): Keyboard’s performance data only
SH-201_r_e.book 25 ページ ２００６年４月２７日 木曜日 午前１１時２８分