Filter
Top Products
70
Parameter list
You cannot edit these parameters by using SH-201 Editor.
Other parameters
Parameter
Value Explanation Panel operation
DEVICE ID
17–24 When you want to transmit or receive System Exclu-
sive messages, set this parameter to match the Device
ID number of the other MIDI device.
1.
Hold down the CANCEL button and press the
TAP button
2.
Press the PRESET button
3.
Hold down the WIDE button and press a
NUMBER button (1–8)
1:
17,
2:
18,
3:
19,
4:
20,
5:
21,
6:
22,
7:
23,
8:
24
4.
Press the CANCEL button
RECORDER
SYNC OUTPUT
OFF, ON If this is “ON,” MIDI Clock messages will be trans-
mitted to an external MIDI device.
1.
Hold down the CANCEL button and press the
TAP button
2.
Press the PRESET button
3.
Press the PLAY/STOP button
PLAY/STOP indicator is lit:
ON
PLAY/STOP indicator is dark:
OFF
4.
Press the CANCEL button
RECORDER
METRONOME
MODE
OFF,
REC-ONLY,
REC&PLAY,
ALWAYS
Specifies when you want the metronome to sound.
OFF:
Metronome will not sound.
REC-ONLY:
Metronome will sound only for re-
cording.
REC&PLAY:
Metronome will sound for record-
ing and playback.
ALWAYS:
Metronome will always sound.
1.
Hold down the CANCEL button and press the
TAP button
2.
Press the PRESET button
3.
Hold down the REC button and press a BANK
button (A–D)
A:
OFF
B:
REC-ONLY
C:
REC&PLAY
D:
ALWAYS
4.
Press the CANCEL button
RECORDER
METRONOME
LEVEL
0–7 Specifies the volume of the metronome.
1.
Hold down the CANCEL button and press the
TAP button
2.
Press the PRESET button
3.
Hold down the REC button and press a NUM-
BER button (1–8)
1–8:
0 (minimum)–7 (maximum)
4.
Press the CANCEL button
SH-201_r_e.book 70 ページ ２００６年４月２７日 木曜日 午前１１時２８分