Filter
Top Products
61
Parameter list
Parameter list
FILTER & AMP parameters
Parameter
Value Explanation Panel operation
FILTER
CUTOFF
0–127 Specifies the cutoff frequency of the filter. Turn the CUTOFF knob (p. 35)
RESONANCE 0–127 Boosts the sound in the region near the filter cutoff frequen-
cy.
Turn the RESONANCE knob
(p. 36)
KEY FOLLOW -200– +200 Causes the filter cutoff frequency to change according to the
key you play.
Turn the KEY FOLLOW knob
(p. 36)
FILTER TYPE LPF, HPF,
BPF, BYPASS
Selects the type of filter that is applied to the waveform. Press the FILTER TYPE button
(p. 34)
SLOPE -12 dB, -24 dB Selects the slope (steepness) of the filter. Press the SLOPE button (p. 35)
FILTER ENV
A
0–127 Specifies the time from when you press the key until the
cutoff frequency reaches its highest (or lowest) point.
Move the FILTER ENV A slid-
er (p. 37)
D 0–127 Specifies the time from when the cutoff frequency reaches
its highest (or lowest) point until it falls to the sustain level.
Move the FILTER ENV D slid-
er (p. 37)
S 0–127 Specifies the cutoff frequency that is to be maintained from
when the attack time and decay time have elapsed until you
release the key.
Move the FILTER ENV S slid-
er (p. 37)
R 0–127 Specifies the time from when you release the key until the
cutoff frequency falls to its minimum level.
Move the FILTER ENV R slid-
er (p. 37)
DEPTH -63– +63 Specifies the direction and amount in which the cutoff fre-
quency will change.
Move the FILTER ENV
DEPTH slider (p. 37)
CUTOFF VELOCITY SENS -63– +63 Specifies how greatly key velocity will affect the cutoff fre-
quency.
Hold down the CANCEL but-
ton and turn the CUTOFF
knob (selectable value: 0– +63)
AMP
LEVEL
0–127 Specifies the volume. Turn the LEVEL knob (p. 38)
PAN L64–63R Adjusts the stereo location of the sound. Hold down the CANCEL but-
ton and turn the KEY FOL-
LOW knob
OVERDRIVE Switch OFF, ON Turns overdrive on/off. Press the OVERDRIVE button
(p. 39)
DRIVE 0–127 Adjusts the depth of the distortion. Hold down the OVERDRIVE
button and turn the LEVEL
knob (p. 39)
AMP ENV
A
0–127 Specifies the time from when you press the key until the
maximum volume is reached.
Move the AMP ENV A slider
(p. 38)
D 0–127 Specifies the time from when the maximum volume is
reached until the volume falls to the sustain level.
Move the AMP ENV D slider
(p. 38)
S 0–127 Specifies the volume that is to be maintained after the attack
time and decay time have elapsed until you release the key.
Move the AMP ENV S slider
(p. 38)
R 0–127 Specifies the time from when you release the key until the
volume falls to the minimum level.
Move the AMP ENV R slider
(p. 38)
LEVEL VELOCITY SENS -63– +63 Specifies how greatly key velocity will affect the volume. Hold down the CANCEL but-
ton and turn the LEVEL knob
(selectable value: 0– +63)
SH-201_r_e.book 61 ページ ２００６年４月２７日 木曜日 午前１１時２８分