Filter
Top Products
21
1. DC POWER JACK
This connector is used in conjunction with the AC/DC adaptor to power the unit. Next to the DC
power jack is a security clamp, which can be fastened over the power cable to prevent it from being
dislodged.
WARNING: ALWAYS USE THE SUPPLIED POWER ADAPTER OR A REPLACEMENT
ADAPTER PURCHASED FROM AN AUTHORIZED STANTON DEALER!!!
2. MASTER OUT LEFT/RIGHT RCA connectors (UNBALANCED)
RCA type unbalanced stereo audio output. These connectors output the mixed audio signal
generated from the SCS.4DJ unit.
3. MASTER OUT LEFT/RIGHT 1/4” TRS connectors (TIP RING SLEEVE BALANCED)
1/4” TRS type balanced stereo audio output. These connectors output the mixed audio signal
generated from the SCS.4DJ unit.
4. MICROPHONE INPUT & VOLUME CONTROLS
The SCS.4DJ has one 1/4” microphone input, located on the front panel. Microphone level is
controlled by the microphone rotary volume control located on the front panel to the right of the
microphone jack. Suitable microphones are any standard dynamic-style microphone.
5. POWER BUTTON
Press the Power Button momentarily to turn on or turn off the unit.
WARNING: Do not remove the power cable or unplug the unit to shut it off. This could cause
data corruption to your drive, damaging your songs and other data. In case the unit does not
respond with the shutdown screen the power button can be pressed and held for 10 seconds
for an emergency shutdown procedure.
6. 1/4” and 1/8” HEADPHONE JACKS & MIX (CUE) CONTROLS
The headphone jacks located on the front of the SCS.4DJ are designed to accept any standard
stereo headphone using either a 1/4’‘ or 1/8” jack. Use the MIX knob to fade between the CUE and
MASTER OUTPUT preview. Use the HEADPHONE VOLUME KNOB to adjust headphone volume.
Both outputs can be used at the same time to share a single headphone signal to two headphones.
7. USB CONNECTOR (type A) (TO UNIT)
This connector is used to attach the USB mass storage device that contains your music library.
Suitable mass storage devices include, but are not limited to: external hard drives, USB thumb
drives, portable digital music players, memory card readers, and active USB hubs.
8. USB CONNECTOR (type B) (FROM UNIT)
This connector is used to attach the SCS.4DJ to a personal computer for MIDI CONTROLLER
mode, This connection is both Windows PC and OSX (Apple) compatible.
9. KENSINGTON® SECURITY LOCK
Use with a Kensignton® security lock for permanent installations to prevent theft or for display
purposes.