Filter
Top Products
33
EQ Knobs
The EQ KNOB allow you to boost or kill the HIGH (treble), MID (midrange) and LOW (bass)
frequencies of your music. Three EQ knobs with central detent allow you to boost or kill (cut to
silent) each of the bands. Turning each EQ KNOB the left side, the EQ’s provide a full frequency
kill. Turning each EQ KNOB to the right, the EQ’s provide a 6dB boost.
Deck Clip Meters
These are two bi-color LEDs that display the audio levels for each deck. The LED is off when audio
is less than -30db, green when audio is between -30db and -9db, yellow when audio is between
-9db and -3db, and red when audio is above -3db.
Master Output Volume Meters
These are two LED ladder meters that display the audio levels for master output jacks.
Microphone LED
The MICROPHONE INPUT has an LED that displays the microphone input level. The LED is off
when audio is lower than -30db, green when audio is between -30db and -9db, yellow when audio
is between -9db and -3db, and red when audio is above -3db.
Channel faders
These control the output level of the Deck A and Deck B pre-cross fader, post auto-gain. Since
SCS.4DJ uses a digital mix engine, the life of all faders/knobs/switches is extended long past that
of typical DJ mixer faders, and will provide you with years of worry-free performance.
Cross Fader
This fader controls the relative mix between Deck A and Deck B. Since SCS.4DJ uses a digital
mix engine, the life of all faders/knobs/switches extended far beyond that of a typical DJ mixer
crossfader, and will provide years of worry-free performance. The crossfader curve (speed at which
volume comes in on each side) can be adjusted in the SYSTEM menu.
Fader Position LED’s
When in AUTO-DJ mode, These LEDs blink while the AUTO DJ is moving the VIRTUALCROSSFADER
POSITION and turn steady on when the crossfade is complete.
NOTE: Crossfader has no Soft Takeover function when in AUTO DJ mode-if you make a movement,
the virtual position will instantly jump to whatever physical position you have moved the crossfader
to.