Filter
Top Products
Panning
Channel level
Master level
Monitor selection
TRIM adjustment
Listening level
6. Turn the channel 1 PAN control all the way to the left.
7. Raise the channel fader to "7" on the scale.
8. Raise the MASTER fader to "7".
9. Set the MONITOR SELECT LINE OUT switch to the left (L-R)
position.
10. While speaking into the microphone, turn the TRIM control in
channel 1 to the right/MIC until the monitor level meter reads
around "0" in average.
11. Slowly turn the MONITOR LEVEL control to the right. You will
hear your voice in the left side of the headphones.
When using a line level source (such as electronic instruments)
instead of the mic, the TRIM does not need to be turned up very
far, if at all.
16
As a trial, let's record your voice on tape.
1. Have in hand a new cassette tape (Type II, C-90 length or shorter).
2. Open the cassette door using the tab on the right of the door.
Insert the cassette tape, and close the cassette door.
3. Press PLAY and allow the tape to run for about 5 seconds. This
will run the tape leader onto the takeup reel, and put the
beginning of the tape in front of the heads.
Loading a cassette
Getting past the leader
tape
How to record on track 1