Filter
Top Products
25
Using Memory Location Points
MEMO 1
MEMO 2
Establishing new MEMOs
Recalculation of MEMOs
Checking MEMO points
Erasing
Loading MEMO points
Two autolocation points can be established in the 424 MKIII's memory
system.
At the desired moment, hold the MEMO IN key and press the LOC 1
key. The MEMO 1 indicator will turn on, showing that the current tape
location is loaded into that register.
Similarly, if you hold MEMO IN and press LOC 2, the current tape
location is loaded as memory point 2 into that register.
Each time LOC 1 or 2 is pressed while MEMO IN is held down, a new
memory point is established, and the previous memory point is
erased.
MEMO points can't be entered while the tape is locating to either
MEMO point or during REPEAT.
If the COUNTER RESET button is pressed, both MEMO points are
automatically recalculated, so they stay the same relative to their
original tape positions.
When the tape is stopped, hold down the desired LOC key
(for 0.5 second or more). The content of the corresponding MEMO
register will be displayed in the counter window.
Remember : If you don't hold down but just hit the LOC key, the tape
is autolocated to the corresponding MEMO point.
Both MEMO points are erased when the cassette is taken out from
the compartment or the power is turned off.