Filter
Top Products
CLP-F01 Selecting & Playing Voices
ENGLISH
30
3 Select a voice for the right hand.
Press a voice button.
4 Select a voice for the left hand.
Press the corresponding voice button while holding the [SPLIT] button. (The
indicator of the Left Voice button will light while the
[SPLIT] button is pressed.)
To turn the variation on or off for the split voice, hold the [SPLIT] button and
press the
[VARIATION] button or the currently-selected voice button.
5 Exit Split mode and return to normal play mode.
Press the [SPLIT] button again so that its indicator goes out.
TIP
[VARIATION] in Split Mode
You can turn the variation on or
off for Split mode voices. Nor-
mally, the voice indicator of the
right voice lights in Split mode.
The [VARIATION] can be used
to turn the variation for the right
voice on or off as required.
While the [SPLIT] button is
held, however, the voice indica-
tor of the left voice lights. In this
state the [VARIATION] button
turns the variation for the left
voice on or off.
TIP
[REVERB] in Split Mode
The reverb type assigned to the
right voice will take priority over
the other. (If the reverb is set to
OFF, the left voice’s reverb type
will be in effect.) Reverb depth
setting via the panel controls
(i.e. pressing the [–/NO] or [+/
YES] buttons while holding the
[REVERB] button — see
page 24) will be applied to the
right voice only.
TIP
[EFFECT] in Split Mode
Depending on the conditions,
one effect type will take priority
over the other. The depth will be
decided according to the depth
default value of the voice combi-
nation. However, using function
F4 (page 45) you can change
the depth value for each voice
as you like. Effect depth setting
via the panel controls (i.e.
pressing the [–/NO] or [+/YES]
buttons while holding the
[EFFECT] button — see
page 25) will be applied to the
right voice only.