Filter
Top Products
16 Welcome to the MD4S
—Owner’s Manual
Disc transport section
A Disc transport buttons
REHE button ......This button is used to rehearse punch-in/out. During rehearsal the REHE
indicator located above the button will light, and while rehearsal is paused
the indicator will blink.
REC button.........This button is used to record. When you press the REC button during
playback, recording will begin from that location on any recordable
track(s). (See “Manual punch-in/out” on page 52 for more information.)
The REC indicator located above the button will light during recording,
and will blink to indicate record pause.
PLAY button .......This button is used to begin normal playback, recording, and rehearsal.
After pressing the REHE button, pressing the PLAY button will enter
rehearsal mode. After pressing the REC button, pressing the PLAPY button
will begin recording. If you press the PLAY button without pressing the
REHE or REC button, normal playback will begin. During playback/
recording/rehearsal, the PLAY indicator located above the button will light.
When playback/recording/rehearsal is paused, the PLAY indicator will blink.
PAUSE button....This button temporarily halts (pauses) playback/recording/rehearsal. After
operation has been paused, pressing the PAUSE button once again will
resume playback/recording/rehearsal from that location. If you do not
operate any buttons for about 10 minutes while the unit is in Pause or Rec
Pause mode, the mode will be canceled automatically.
TOC WRITE
REHE REC PLAY STOP
PAUSE
IN OUT
SONG SEARCH
LAST REC SEARCH
MARK SEARCHREPEAT
AUTO
PUNCH I/O
AB
DATA CURSOR
PHONES PUNCH I/O
PITCH
EJECT
ADJUST EDIT UTILITY
CH1
BUS
CH2
REC SELECT
CH3 CH4
LRLR
PEAK HOLD DISPLAY
MULTITRACK MD RECORDER
1234
EXIT
ENTER
SET
MARK
L
K
J
M
N
O
P
Q
R
9
6
7
5
8
2
1
3
4
* Please remove the protective film from the panel.
If the film is left on, the adhesive may break down and soil the unit.