Filter
Top Products
Punch-in/out 59
—Owner’s Manual
Actually performing the auto punch-in/out (multi-take)
7. From a stopped or paused condition, press the REC button.
The REC indicator will blink, and the display will indicate “TAKE 1.” Auto punch-in/out will
be in record-pause mode, ready to record the first take (take 1).
8. Press the PLAY button to begin the actual auto punch-in/out.
When you reach the post-roll point, the MD4S will automatically stop, and the display will
indicate “NEXT TAKE.”
Recording the next take
9. With “NEXT TAKE” shown in the display, press the ENTER button.
The display will briefly indicate “TAKE 2 Load.” Then the display will change to “TAKE 2,” and
the MD4S will be in record-pause mode for take 2 of the auto punch-in/out.
10. Press the PLAY button to begin auto punch-in/out.
When you reach the post-roll point, the MD4S will automatically stop, and the display will
indicate “NEXT TAKE.” If you wish to record another take, press the ENTER button to enter
record-pause mode for the next take. If you wish to listen to the takes that you have recorded,
advance to the following procedure with “NEXT TAKE” still displayed.
Auditioning each take
11. When you have finished recording auto punch-in/out takes and the display
indicates “NEXT TAKE,” rotate the DATA dial to make the display read “MONI
TAKE.”
12. Press the ENTER button.
The display will indicate “TAKE X:MONI” (X will be the take number).
13. Rotate the DATA dial to select the take that you wish to hear, and press the
ENTER button to playback the selected take.
When you reach the post-roll point (or press the STOP button), the MD4S will stop, and you
will again be able to select a take.
If you press the EXIT button when the display reads “TAKE X:MONI,” you will return to the
“NEXT TAKE” display.
Selecting the best take
14. When the display reads “TAKE X:MONI,” rotate the DATA dial to select the
best take.
The “TAKE X” display will blink.
15. Rotate the CURSOR shuttle toward the right to make the “MONI” display
blink.
Note: Takes 2 and following will always begin with the actual auto punch-in/out. If you wish
to rehearse, you must press the REHE button.
Tip: To audition the original, rotate the DATA dial to make the display read
“ORIGIN:MONI.”