Filter
Top Products
Front and rear panel 23
—Owner’s Manual
Rear panel
A POWER switch
This switch is used to turn the MD4S on and off.
B AC IN
Connect the included power cable here.
C AUX SEND 1, 2 jacks
These are 1/4" phone jacks that output the signals from the input channels as adjusted by the
AUX controls (input channel
5). Normally they are used as effect send jacks to send signals
to external effect processors (page 45).
D MONITOR OUT jacks
These are RCA phono jacks that output the monitor signal selected by the MONITOR
SELECT switch (monitor/master
J). Connect them to your hi-fi system or to amplified
monitor speakers.
E STEREO OUT jacks
These are RCA phono jacks that output the signal of the ST bus that has passed through the
STEREO fader (monitor/master
L). During mixdown, connect these jacks to the inputs of
your master recorder.
F 2TR IN jacks
These are RCA phono jacks for connecting a line-level stereo device. Normally they are
connected to the output jacks of your DAT or other master recorder.
G TRACK DIRECT OUT 1–4 jacks
These are RCA phono jacks which individually output the signals from tracks 1–4 (the signals
currently being recorded/played). Normally they are used to connect the MD4S to the input
jacks of a large mixer when you wish to use an external mixer to mix the playback of the MD4S
recorder tracks.
RRR 42
LLL
2TR INAUX SENDAC IN
31
MIDI
OUT
STEREO
OUT
MONITOR
OUTPOWER
ON/ OFF
TRACK
DIRECT OUT
THRU IN
12
7
8
4 56
321
CAUTION
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.