Filter
Top Products
Creating Plug-in Custom Voices
Creating Plug-in Custom Voices
Reference 107
4 Load the appropriate files to both the 9000Pro and your com-
puter.
● When editing voices on an installed Plug-in Board for the first time:
Make sure to load the appropriate files (on the floppy disk included with the
9000Pro) to the 9000Pro as follows. For the PLG150-AN board only, you'll need to
also load the appropriate file (below) to your computer.
● When editing voices on an installed Plug-in Board in subsequent editing
sessions:
Before starting to make additional edits to a previously edited voice, also make sure
to load the same edited data (the data that you saved in steps #7 and #8) to both the
Flash ROM (on the 9000Pro) and the computer.
5 Use the same operation as in Steps #1 - #5 of the "Basic Pro-
cedure" on page 101, paying attention to the following
points.
• In step #4 of "Basic Procedure,” the following display appears on the
9000Pro's LCD.
• As described in step #4 of "Basic Procedure,” use the Bulk Send operation
(XGworks or XGworks lite) to transfer the edited data from the computer
to the board.
• As described in step #5 of "Basic Procedure,” execute the Board Custom
Voice Backup operation.
6 Execute the Store operation in the Native System Parameter
display (page 105).
7 Save the edited voice to a disk via the Plug-in Manager func-
tion (page 68).
8 Save the edited voice to the PC.
File name to be loaded
to the 9000Pro to the PC
PLG150-AN 150AN CsVce.xvc 150AN CsVce.ANS
PLG150-PF 150PF CsVce.xvc —
PLG150-DX 150DX CsVce.xvc —
PLG150-VL 150VL CsVce.xvc —
105