Filter
Top Products
Custom Voice Creating
Custom Voice Creating
Reference 95
● E1: WAVEFORM
See page 85 for details about Waveform.
No sound is
produced.
No sound is
produced.
LOW
HIGH
No sound is produced.
No sound is produced.
HIGH
LOW
127
0
Use the CATEGORY, VOICE, and WAVE-
FORM LCD buttons to select the waveform
for the custom voice. (This is the “raw”
sound on which the voice is based.) Wave-
forms created by the SAMPLING feature
(page 84) are also available for selection in
the “SAMPLING” CATEGORY.
• When a Drum Kit is selected, the WAVE-
FORM parameter is replaced by the
INSTRUMENT parameter, and individual
instruments can be selected rather than
waveforms.
NOTE LIMIT specifies the
note range over which the
voice will sound, and
VELOCITY LIMIT sets the
maximum velocity range for
the voice.
These parameters adjust
the pitch of the voice.
COARSE tunes in semitone
steps and FINE tunes in 1-
cent steps (a cent is 1/100th
of a semitone).
Sets the waveform volume.
Sets the amount of delay before the sound is heard
— in other words, the time between when the key is
pressed and when the envelope begins. The higher
the value the longer the delay.
Sets the position of the voice in the stereo field.
• Example for NOTE LIMIT
• Example for VELOCITY LIMIT
• When the voice OCTAVE is set
to a value other than “0”, the
range specified by the NOTE
LIMIT parameters is shifted by
the corresponding amount and
some notes may not sound. If
this happens check the R1
OCTAVE setting in the MIXING
CONSOLE TUNE display.
• NOTE LIMIT and VELOCITY
LIMIT are not available for the
Drum Kits.
93