Filter
Top Products
Listening to Patches (Play Mode Operation)
Listening to Patches
(Play Mode Operation)
Panel Display in Play Mode
Selecting a Patch
10
ZOOM 707II GUITAR
1.
In play mode, press one of the
[
W
]/[
Q
] foot switches.
Pressing the [
Q
] foot switch moves to the next
higher patch, and pressing the [
W
] foot switch
moves to the next lower patch.
2.
To directly switch the bank, use the
TYPE [
W
]/[
Q
] keys.
Pressing the TYPE [
Q
] key moves to the next
higher bank, and pressing the TYPE [
W
] key
moves to the next lower bank.
While playing a rhythm pattern, direct bank
selection is not available.
3.
It is also possible to set up the unit so
that only patches from the USER
group or from the PRESET group are
switched. To do this, press both TYPE
[
W
]/[
Q
] keys together.
With each push, the group from which patches
can be selected is toggled as follows.
To set up the unit so that the patch sound is
switched only after confirmation, see p. 23.
HINT
02A202
Both groups
USER group
only
PRESET group
only
NOTE
A0A1A9B0F9
5
9
0
0010910
USER group
PRESET group
The condition where you call up patches stored in the memory of the 707II and use them for
playing your instrument is called "play mode". This is the condition the unit is in when you
turn the power on. The various operations possible in play mode are described in this
section.
In play mode, the panel shows the following information.
A0
Patch name
Bank (A - F, 0 - 5)
Patch number (0 - 9)
When a dot (.) is shown here, an
effect parameter has been changed.
When a dot (.) is shown here, patches
can be selected from either the USER
group or the PRESET group.
Module LEDs corresponding to modules that
are ON in the currently selected patch are lit.