Filter
Top Products
Preparations
Preparations
Inserting Batteries and a SmartMedia card
6
ZOOM 707II GUITAR
1.
Turn the unit over and open the
battery compartment cover.
2.
Insert four fresh IEC R6 (size AA)
batteries into the battery compartment.
The use of alkaline batteries is
recommended.
The correct battery orientation is indicated
inside the battery compartment.
3.
To store patch and sample data,
insert a SmartMedia card into the
card slot, as shown above.
◆ Caution ◆
●
If the card is inserted upside down or
with wrong orientation, it does not go
all the way in. Do not try to force the
card in, because this will damage the
card.
●
Never insert or remove the
SmartMedia card while power to the
unit is turned on. Otherwise all data on
the card may be lost.
●
Standard SmartMedia cards (designed
for 3.3V) with a capacity from 16 – 128
MB can be used.
●
When wishing to use a SmartMedia
card that has been formatted in other
equipment such as a computer or
digital camera, you must format the
card again in the 707II, as described
on page 31.
●
To store the contents of a SmartMedia
card in a computer, a SmartMedia
card reader/writer is required.
4.
Close the battery compartment cover.
• If the indication "BATT" appears on the display,
the batteries are exhausted. Replace the
batteries as soon as possible.
• When not using the unit for an extended period,
remove the batteries to prevent the possibility of
damage by leaking battery fluid.
PATCH NAME
NOTE
SmartMedia card
Four IEC R6
(size AA) batteries
When wishing to power the 707II from batteries, insert them as shown below. When wishing
to store patch data or sample data on a SmartMedia card, insert the card as shown below.