Filter
Top Products
19
ZOOM 707II GUITAR
Because the ISOLATOR, EQ, and TOTAL
modules have many parameters, settings are
divided into several pages. To switch the page,
press the [EDIT] key while the corresponding
module LED is lit.
4.
To switch the on/off status of the
selected module, press both MODULE
[
E
]/[
R
] keys together.
When you change the module on/off status,
effect type selection, or a parameter value, a dot
(.) appears at the "EDITED" position of the
[BANK/PATCH] indicator. When this dot is
shown in edit mode, it means that the currently
selected module has been edited. If you return
the module to the original setting, the dot
disappears.
5.
To change the effect type of the
currently selected module, press one
of the TYPE [
W
]/[
Q
] keys.
6.
To change a parameter setting, use
the parameter knobs 1 – 3.
Parameter knobs 1 – 3 serve for adjusting three
parameters of the currently selected module.
When you operate a knob, the display shows the
parameter name, and the [BANK/PATCH]
indicator shows the current setting value.
For example, if the effect type ROOM is
selected for the REV module, parameter knobs
1 – 3 control the following parameters.
●
Parameter knob 1:
TIME
●
Parameter knob 2:
TONE
●
Parameter knob 3:
MIX
7.
If you want to check the current
setting without moving the parameter
knob, press the TYPE [
W
]/[
Q
] keys
together. With each push of the two
keys, the names of parameters 1 – 3
and the respective settings are
shown.
8.
To directly switch the effect type of
the DRIVE module, use the [DRIVE]
knob and [DRIVE VARIATION] key.
As in play mode, the [DRIVE] knob and
[DRIVE VARIATION] key directly control the
effect type of the DRIVE module.
9.
Repeat steps 3 – 8 to edit other
modules.
10.
When editing is completed, press the
[PLAY] key or the [CANCEL/EXIT] key.
The 707II returns to the play mode. A dot (.)
appears at the "EDITED" position of the
[BANK/PATCH] indicator if any aspect of the
patch has been edited.
If you wish to keep the patch, be sure to perform
the store operation. Otherwise all changes will be
permanently lost as soon as you switch to
another patch. (
→ P. 20)
NOTE
TIME
20
TONE
10
MIX
7
First push
Second push
Third push
24
When a dot (.) is
shown here, the
currently selected
module was edited.
NOTE
HALL
PD
Effect type Shown if selected effect can
be controlled by pedal
Changing the Sound of a Patch (Edit Mode)