Filter
Top Products
14
•If the indication "NO" is followed by a "*", a
sample is recorded in that number.
• If you select a number in which a sample has
already been recorded, the previous sample will
be overwritten. Be careful not to overwrite a
sample that you wish to keep.
• For information on how to assign a sample to a
patch when storing, see p. 27.
• For information on how to delete unwanted
samples from a SmartMedia card, see p. 31
4.
Use the TYPE [
W
]/[
Q
] keys to select
"GT" or "AUX" as input source.
When you press one of the TYPE [
W
]/[
Q
]
keys, the currently selected input source is
shown on the display. Select one of the
following two sources.
●
GT
Signal from [INPUT] jack
●
AUX
Signal from [AUXI IN] jack
• If "GT" is selected, the signal after passing the
effects is sampled. If "AUX" is selected, the
effects are bypassed.
• When recording from the [AUX IN] jack, you can
minimize noise and distortion by turning the
[OUTPUT] knob up past the midway point and
adjusting the output level of the external source
so that the volume is about equal to that of a
guitar.
• After recording, you can use the SP LVL
parameter to control the playback level of the
sample.
5.
Press the [
Q
] foot switch and play the
phrase you want to record (or start
playback at the external source
component).
During sampling, the indication "REC" is
shown on the display. The module LEDs on the
panel show the elapsed sampling time.
•When sampling to internal memory, sampling
ends when all module LEDs are lit.
• When sampling to SmartMedia card, the module
LEDs go through the cycle repeatedly.
6.
To stop sampling, press the [
W
] foot
switch.
If you do not press any key after starting to
sample, sampling automatically ends when the
maximum sampling time is up (6 seconds with
internal memory, 4 minutes with a 16 MB
SmartMedia card).
7.
Use parameter knob 2 to select the
sample playback mode.
When you operate parameter knob 2, the
indication "SPMODE" appears on the display.
The [BANK/PATCH] indicator shows the
playback mode. The following settings are
available.
●
n1
Normal speed playback
●
n2
Half tempo, half pitch playback
●
P2
Half tempo, normal pitch playback
●
n4
Quarter tempo, quarter pitch playback
●
P4
Quarter tempo, normal pitch playback
8.
Use the foot switches and panel keys
to control sample playback (start/
stop/rewind/fast-forward).
While the sampler function is on, you can use
the foot switches and panel keys for one-shot
playback.
SPMODE
N1
NOTE
6 seconds
HINT
HINT
NOTE
2
SP NO
ZOOM 707II GUITAR
Listening to Patches (Play Mode Operation)