Filter
Top Products
25
For example, when PDLMIN is set to 4 and
PDLMAX to 8, the parameter adjustment range
will be limited as shown in the illustration
below.
When PDLMIN is set to 7 and PDLMAX to 2,
pushing the pedal decreases the parameter
value, and the range is as shown below.
7.
Press the [STORE/EXECUTE] key to
store the patch.
The module which is assigned to the pedal will
automatically be stored as ON.
8.
In play mode, move the pedal while
playing your guitar.
The parameter assigned to the pedal changes.
9.
Push the pedal fully down.
The module which is assigned to the pedal is
switched between on and off. If the pedal is
assigned to the sampler, the sampler function is
switched on or off.
If the pedal is assigned to the volume, pushing
the pedal fully down does not perform any
switching action.
NOTE
MAX=2
MIN=7
MAX=8
MIN=4
ZOOM 707II GUITAR
Adjusting the Expression Pedal
The expression pedal is adjusted for optimum operation at the factory, but sometimes,
readjustment may be necessary. If pushing the pedal fully down does not have a strong
effect, or if the volume or sound changes excessively even when the pedal is only lightly
pushed, adjust the pedal as follows.
1.
Turn power to the 707II on while
keeping the [PEDAL] key depressed.
The indication "MIN" appears on the display.
2.
With the expression pedal fully raised,
press the [STORE/EXECUTE] key.
The display indication changes to "MAX".
3.
Push the expression pedal fully down
and then lift your foot off the pedal.
The pedal goes back a little.
4.
Press the [STORE/EXECUTE] key.
The adjustment is completed, and the unit
returns to the play mode.
• The position of the pedal in step 3 determines the
on/off switching point. If you want the pedal to
perform on/off switching with a lighter touch, set
the pedal to a somewhat higher position.
• If the indication "ERROR" appears, return to step
2 and repeat the procedure.
HINT
Push strongly, so that
pedal touches here.
When foot is lifted,
pedal returns slightly.
MAX
Other Functions