Filter
Top Products
7
ZOOM 707II GUITAR
1.
Make sure that the amplifier and the
707II are off.
Turn the volume at the amplifier to minimum.
2.
To power the unit from the AC
adapter, insert the small plug of the
adapter cable into the [DC 9V] jack on
the 707II. Then plug the adapter into
an outlet.
3.
Connect the guitar to the [INPUT] jack
of the 707II, using a mono cable.
4.
Connect the [OUTPUT/PHONES] jack
of the 707II to the guitar amplifier,
using a mono cable.
You can also use a Y cable to supply the signal
in stereo to two amplifiers.
5.
To monitor the sound with headphones,
plug the phones into the [OUTPUT/
PHONES] jack.
6.
Turn power on in the following order:
707II
→
amplifier.
If you turn the 707II on while the amplifier is
already powered up, damage to the speaker may
result. Always turn power to the amplifier on last.
7.
Raise the volume setting of the
instrument and amplifier, and adjust
the [OUTPUT] knob on the rear panel
of the 707II.
NOTE
Preparations
AC adapter
Guitar amplifier
Guitar
CD player or similar
Headphones
Getting Connected