Filter
Top Products
ZOOM 707II GUITAR
23
1.
To change the patch call method to
preselect, hold down the [
Q
] foot
switch while turning power to the
707II on.
2.
Select the patch in play mode.
When you select a patch in this condition, the
display and [BANK/PATCH] indicator show
the new patch (flashing), but the sound does not
change.
3.
To confirm the patch change, press
both [
W
]/[
Q
] foot switches together.
The display and [BANK/PATCH] indicator stop
flashing, and the unit switches to the new patch,
causing the sound to change.
To return to the default patch selection method,
turn the 707II off and on again.
HINT
A3A3
A0 A1 A2 A3
Other Functions
Changing the Patch Call Method
In the factory default condition, patches are switched as soon as you make the selection,
resulting in an immediate change in the sound. If you want to change to a distant patch, all
the intermediate patches will briefly change the sound, which may not be desirable,
especially during a performance. In such a case, you can change to the preselect method.
When the preselect method is enabled, you first select the desired patch, but the sound does
not change until confirmed by you.
Using the Pedal to Control an Effect
You can use the expression pedal of the 707II to control the parameter, on/off status, or
volume level of a specific effect. The pedal adjustment range can be memorized individually
for a patch.
1.
Select a patch in play mode.
2.
Use the [PEDAL] key to select the
module/effect type to be controlled
with the expression pedal.
Each push of the [PEDAL] key cycles through
the [PEDAL] LEDs as shown below.
The [PEDAL] LEDs indicate the module/effect
type assigned to the pedal. The meaning of the
LEDs is explained below.
●
WAH
The expression pedal functions as a pedal wah.
The effect type P-WAH (pedal wah) of the
MODULATION module is assigned to the
pedal, and the FREQ parameter can be adjusted.
Even if another effect type is currently selected
for the MODULATION module, the effect type
is temporarily switched to P-WAH.
●
PITCH
The expression pedal functions as a pitch
shifter. The effect type P-PIT (pedal pitch) of
the MODULATION module is assigned to the
pedal, and pitch can be adjusted. Even if another
effect type is currently selected for the
Lit
Out
(Pedal is inactive)