Filter
Top Products
Using the Expression Pedal
ZOOM G7.1ut
32
NOTE
It is also possible to specify the same parameter
for more than one control target, but in some
cases, extreme parameter value changes may lead
to noise. This is not a defect.
8. When all settings for the built-in
expression pedal have been made,
press the [EXIT] key.
The unit returns to play mode.
9. If required, store the patch.
NOTE
Any changes in pedal settings will be lost when
you select a new patch. Be sure to store the patch
if you want to keep the changes (
→ p. 27).
Adjusting the built-in
expression pedal
The built-in expression pedal of the G7.1ut is
adjusted for optimum operation at the factory, but
sometimes, readjustment may be necessary. If the
action of the pedal seems to be insufficient, or if a
large change occurs even if the pedal is only
lightly pushed, adjust the pedal as follows.
1. Hold down the [PEDAL SETTING] key
while turning on power to the unit.
The display indication changes as follows.
2. With the expression pedal fully raised,
press the [STORE/SWAP] key.
The display indication changes as follows.
3. Push the expression pedal fully down
and then lift your foot off the pedal.
4. Press the [STORE/SWAP] key.
The adjustment is completed, and the unit returns
to the play mode.
HINT
• The module on/off switching point is not
affected by the pedal position in step 3.
• For information about the module on/off
switching function, see page 31.
• If the indication “ERROR” appears, return to
step 2 and repeat the procedure.
Setting...min
Setting...min
PDL Calibration
PDL Calibration
Pedal fully raised
Setting...MAX
Setting...MAX
PDL Calibration
PDL Calibration
Push strongly,
so that pedal
touches here
When foot is lifted,
pedal returns slightly
Using the Expression Pedal
ZOOM G7.1ut
33
Using an external
expression pedal
An optional expression pedal (FP01/FP02) can be
connected to the CONTROL IN jack of the
G7.1ut and used independently from the built-in
expression pedal as a volume pedal.
1. Plug the external expression pedal
into the CONTROL IN jack and turn
power to the G7.1ut on.
2. Operate the external expression
pedal in play mode, manual mode, or
edit mode.
The volume level changes.
HINT
The external expression pedal always functions as
a volume pedal. It can also be used as a controller
for sending MIDI messages (
→ p. 41).