224 CHAPTER 8: MOBILITY DOMAIN COMMANDS
Syntax — clear mobility-domain
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX switch is not configured
as part of a Mobility Domain.
Examples — To clear a Mobility Domain from a WX switch within the
domain, type the following command:
WX1200# clear mobility-domain
success: change accepted.
See Also
■ “clear mobility-domain member” on page 224
■ “set mobility-domain member” on page 226
■ “set mobility-domain mode member seed-ip” on page 227
■ “set mobility-domain mode seed domain-name” on page 228
clear
mobility-domain
member
On the seed WX switch, removes the identified member from the
Mobility Domain.
Syntax —
clear mobility-domain member ip-addr
■ ip-addr — IP address of the Mobility Domain member, in dotted
decimal notation.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX switch member is not
configured as part of a Mobility Domain or the current WX switch is not
the seed.
