280 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
History — Introduced in MSS Version 3.0.
A radio can increase power again if required to preserve the minimum
data rate for an associated client.
Examples — The following command changes the power-backoff
interval for radios in radio profile rp2 to 15 seconds:
WX4400# set radio-profile rp2 auto-tune
power-backoff-timer 15
success: change accepted.
See Also
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune power-config” on page 280
■ “set radio-profile auto-tune power-interval” on page 281
set radio-profile
auto-tune
power-config
Enables or disables dynamic power tuning (RF Auto-Tuning) for the MAP
radios in a radio profile.
Syntax —
set radio-profile name auto-tune power-config
{enable | disable}
■ name — Radio profile name.
■ enable — Configures radios to dynamically set their power levels
when the MAPs are started.
■ disable — Configures radios to use their statically assigned power
levels, or the default power levels if unassigned, when the radios are
started.
Defaults — Dynamic power assignment is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — When RF Auto-Tuning for power is disabled, MSS does not
dynamically set the power levels when radios are first enabled and also
does not tune power during operation with associated clients.
