set spantree portfast 337
See Also
■ “clear spantree portcost” on page 316
■ “clear spantree portvlancost” on page 317
■ “display spantree” on page 320
■ “display spantree portvlancost” on page 325
■ “set spantree portvlancost” on page 338
set spantree
portfast
Enables or disables STP port fast convergence on one or more ports on a
wireless LAN switch.
Syntax —
set spantree portfast port port-list {enable | disable}
■ port port-list — List of ports. MSS enables the feature on the
specified ports.
■ enable — Enables port fast convergence.
■ disable — Disables port fast convergence.
Defaults — STP port fast convergence is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use port fast convergence on ports that are directly connected
to servers, hosts, or other MAC stations.
Examples — The following command enables port fast convergence on
ports 2, 5, and 7:
WX1200# set spantree portfast port 2,4,7 enable
success: change accepted.
See Also
■ “display spantree portfast” on page 324
set spantree portpri Changes the STP priority of a network port or ports for selection as part
of the path to the STP root bridge in the default VLAN on a wireless LAN
switch.
