14
RADIUS AND SERVER GROUP
COMMANDS
Use RADIUS commands to set up communication between an WX switch
and groups of up to four RADIUS servers for remote authentication,
authorization, and accounting (AAA) of administrators and network
users.
Commands by
Usage
This chapter presents RADIUS commands alphabetically. Use Table 75 to
locate commands in this chapter based on their uses.
(For information about RADIUS attributes, see the RADIUS appendix in
the Wireless LAN Switch and Controller Configuration Guide.)
clear radius Resets parameters that were globally configured for RADIUS servers to
their default values.
Table 75 RADIUS Commands by Usage
Type Command
RADIUS Client “set radius client system-ip” on page 408
“clear radius client system-ip” on page 405
RADIUS Servers “set radius” on page 407
“set radius server” on page 409
“clear radius” on page 403
“clear radius server” on page 405
Server Groups “set server group” on page 411
“set server group load-balance” on page 412
“clear server group” on page 406
