set spantree portvlanpri 339
■ vlan vlan-id — VLAN name or number. MSS changes the cost on
only the specified VLAN.
Defaults — The default port cost depends on the port speed:
■ 10Mbps — the default is 100.
■ 100Mbps — the default is 19.
■ 1000Mbps — the default is 4.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the cost on ports 3 and 4
to 20 in VLAN mauve:
WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also
■ “clear spantree portcost” on page 316
■ “clear spantree portvlancost” on page 317
■ “display spantree” on page 320
■ “display spantree portvlancost” on page 325
■ “set spantree portcost” on page 336
set spantree
portvlanpri
Changes the priority of a network port or ports for selection as part of the
path to the STP root bridge, on one VLAN or all VLANs.
Syntax —
set spantree portvlanpri
port-list priority value {all | vlan vlan-id}
■ port-list — List of ports. MSS changes the priority on the specified
ports.
■ priority value — Priority value. You can specify a value from 0
(highest priority) through 255 (lowest priority).
■ all — Changes the priority on all VLANs.
■ vlan vlan-id — VLAN name or number. MSS changes the priority on
only the specified VLAN.
