Navigation Map
A-5
View and Edit
Configuration Parameters ↕
↕↕
↕
Communication Status..
RS-232 Port Configuration..
PPP Configuration..
Modem Operation..
Com1
Configuration ..
SNMP Configuration..
Com2
Configuration ..
Modem Status
..
PPP Status
..
Baud-rate 38400
Change to 9600
19200
4800
2400?
Comm Route PPP
Change to Dir ?
Comm Route Dir
Change to PPP ?
Term Emul Enab/Disab
Change to Disab/Enab?
PPP Name
..
PPP Password
..
Modem Functions
..
Modem Setup
..
Scan/Init Modem
Scan/Re-Init Modem
Dial-out Modem
Hang-up Modem
No Modem Port Configured
Communication Parameters..
Caching Parameters..
Host-side SCSI Parameters..
Drive-side SCSI Parameters..
Disk Array Parameters..
Redundant Ctlr Configuration..
Controller Parameters..
Write-Back Cache
Enabled/Disabled ..
Optimization for
Random/Sequential I/O ?
Auto ~ 128, 256, 512, 1024
1, 2, 4, 8, 16, 32
1, 2, Def (4), 8, 16, 32, 64
1, 2, 4, 8, 16, Def (32), 64, 128, 256
Device Type -
Device Qualifier
Support Removable Media -
LUN Application -
No Device (0x7f)
Direct-access(0)
Sequential(1)
Processor(3)
CD-ROM(5)
Scanner(6)
MO Device(7)
Storage Array(c)
Unknown (0x1f)
Connected, Support Not Connected
Enabled, Disabled
All Undefined LUN, Undefined LUN-0’s
Sector Ranges -
Head Ranges -
Cylinder Ranges -
Variable, 32, 64, 127, 255
Variable, 64, 127, 255
Variable, <1024, <32768, <65536 Cylinders
Loop Only
PtoP Only
Loop Preferred
PtoP Preferred
Configure Modem Port..
Modem Operation Modes..
Modem Initialization..
Dial-out Functions..
Deconfigure
Modem Port ?
Configure Modem
on COM1/COM2 ?
Custom ModemInit
None-DefaultUsed
Custom Modem
Init - None/Replace/Append ?
Custom Init Cmd:
AT
Dial-out Command
..
Auto Dial-out
on Init Enabled/Disabled
Dial-out Timeout
* seconds ?
Dial-out Retry
Count -
?
Retry Interval-
minutes ..
Event Condition?
All Events/Critical&Warning/Critical Events/Disabled
Community Name -
Not Set
Trap Destination
1 to 4 Parameters ..
Community Name :
Community Name :
Trap IP Address :
Maximum Queued I/O Count - ***..
LUNs per Host SCSI ID - **..
Num of Host-LUN Connect - **..
Tag per Host-LUN Connect - **..
Fibre Connection Options
Peripheral Dev Type Parameters.
Cyl/Head/Sector Mapping Config..
Dial-out Cmd:
ATD
