Front Panel Operation
5-22
5.10 Viewing and Editing Host LUNs
Viewing and Deleting LUN Mappings
Press ENT for two seconds to enter the
Main Menu. Press ▼ or ▲ to select
"View and Edit Host Luns", then press
ENT.
Press ▼ or ▲ to select a host ID, then
press ENT to proceed.
Press ▼ or ▲ to browse through the
LUN number and its LUN mapping
information.
Press ENT on the LUN you wish to
delete.
Press ENT for two seconds to confirm
deletion. The deleted LUN has now
been unmapped.
For LUN Filtering functions, e.g., Create Host Filter Entry, Edit Host-
ID/WWN Name List, please refer to Chapter 8 “Fibre Operation.”
Pass-through SCSI Commands
Pass-through SCSI commands facilitate functions like downloading
firmware for drives or devices (not controller firmware), setting
SCSI drive mode parameters, or monitoring a SAF-TE/S.E.S. device
directly from the host. To perform such a function, the SCSI device
must be mapped to a host SCSI ID.
From the Main Menu, press ▼ or ▲ to
select "View and Edit Host LUNs."
If you have primary and secondary
controllers, use the ▼ or ▲ to select the
controller for the device that you
would like to map.
Press ▼ or ▲ to choose to map a SCSI
ID to "Physical Drive" or other device
and then press ENT.
View and Edit
Host Luns
Map Channel=0
ID=0 Pri Ctlr ?
Map to
Physical Drive ?
View and Edit
Host Luns ↕
CH=0 ID=002
Sec. Ctlr ..
CH=0 ID=0 LUN=0
Mapto LG0 PRT0
Delete CH0 ID0
LUN=00 Mapping ?
CH=0 ID=0 LUN=0
Not Mapped
