Infortrend
A-6
Motor Spin-Up
Reset at Power-Up
Init Disk Access Delay -
SCSI I/O Timeout
Periodic SAF-TE ChkTime -
Maximum Tag Count
Periodic Drive ChkTime -
Periodic Drv Swap AutoChk -
SMART Mode -
Fibre Chl Dual Loop -
Enable/Disable Motor
Spin-Up ?
Enable/Disable Reset
at Power-Up ?
Set Disk Delay
Time - No Delay to 75 seconds?
500 ms, 1, 2, 4, 6, Def (7), 8, 10 seconds ?
Disable, 1, 2, 4, 8, 16, 32, 64, 128 seconds ?
Disable, 1/2, 1, 2, 5, 10, 30 seconds ?
Disable, 50ms, 100ms, 200ms, 500ms, 1, 2, 5, 10, 20, 30, 60 seconds ?
Disable, 5, 10, 15, 30, 60 seconds ?
SMART Mode -
Disable?
Detect?
Perpetual Clone?
Clone + Replace?
Enable/Disable Fibre
Chl Dual Loop ?
Rebuild Priority
Low
Normal
Improved
High ?
On LD Initialize Writes
On LD Rebuild Writes
On Normal Drive Writes
Enable/Disable ?
RC Communication
Channel-SCSI Bus/ Fibre Loops
Secondary Ctlr
RS232 Enabled/Disabled..
Controller Name:
Not Set
LCD Title Disp -
Controller Name/Controller Logo?
Passwd Validation
Timeout-Disabled?
Enter Ctlr Name:
Controller Password setDisable, 1, 2, 5 min, ...Always
Ctlr Unique
ID- ****
1 to 65535, must be different for each controller
SDRAM ECC -
Enable/Disable ?
View and Edit
Peripheral Device ↕
↕↕
↕
View Peripheral Devices Status..
Set Peripheral Devices Entry..
Define Periph. Active Signal
Adjust LCD Contrast
Ctlr Peripheral Device Configuration..
Redundant Ctlr Function
UPS ...
Redundant Ctlr
Function Disabled
Enable Redundant
Ctlr: Autocfg ?
Primary ?
Secondary ?
UPS Power
Status
Enable/Disable UPS
Power Status ?
Set UPS Fail
Sig Active Low/Active High ?
LCD Contrast :
❚
❚
❚
❚
❚
❚
❚
------
View Ctlr Periph
Device Status..
Voltage Monitor
..
Temperature
Monitor ..
[+3.3V] 3.***V
[+5V] 5.***V
[+12V] 12.***V
Operation Normal
[CPU] **.*°C
[Board1] **.*°C
[Board2] **.*°C
in Safe Range
Temperature and
Voltage Parms ..
Trigger Threshold
for
3.3V Event
5V Event
12V Event
CPU Temp Event
Board Temp Event
Upper Temp
Event-Def (**C)
Lower Temp
Event-Def (**C)
Range *.*V-*.*V
Range *°C-**°C
Input :
Drive-side SCSI Parameters..
Disk Array Parameters..
Redundant Ctlr Configuration..
Controller Parameters..
View and Edit
Configuration Parameters ↕
↕↕
↕
