A SERVICE OF

logo

Open as PDF
next previous
SLIP
LCS60 Configuration and Connection for SLIP Service
Figure 5-2: Configuring SLIP Service
maxsessions
config protocol
tcpip slip
ipas
start all
obtain IP
address
configure client
side of SLIP
service
etherif
srvsetup
1 . Obtain the Ethernet IP address for the LCS60 and obtain an IP network
address for each IP network security group. At least one IP address, in
addition to the Ethernet address, is required for SLIP and PPP service in
order to configure the physical connection used for SLIP/PPP. These IP
network addresses must be different from the LCS60’s Ethernet internet
address.
2 . Enter the lcsadm interface.
3 . Add the SLIP service:
From Config>, enter protocol, or config protocol from Top>.
Add tcpip (as required).
Add slip.
4 . Define the SLIP service sessions (maxsessions):
From the Config directory, enter max, or enter config maxsessions
at the Top directory.
5-2 Issue 3