A SERVICE OF

logo

LCS60 Software
Introduction
This chapter describes the steps required for configuring the LCS60 software. An
example of a network topology is shown in Figure 3-1.
Figure 3-1: Example Network
Mac
Mac
LCS60
Router
LCS200
Mac
Modem Pool
LCS60
}
Remote Access Clients
LAN
Note: Refer to Chapters 4, 5, 6, and 7 for examples of
PPP, SLIP, ARAP and gateway configurations.
Lucent Data Switch
78:1FC (IPX)
Note: All addresses and names in this figure are examples only.
Preliminary Hardware Requirements
Before configuring your LCS60, make sure you have followed the instructions in
Chapter 2 for hardware installation.
Issue 3 3-1