SLIP
LCS60 Configuration and Connection for SLIP Service
Assign the number of sessions. The total number of sessions
through the LCS60 is 120 when SLIP is configured.
5 . Set up IP network security groups (ipas):
Enter ipas at the Top>Config># prompt or enter config ipas from the
Top directory.
Follow the on-screen instructions for configuring IP network
security groups for the various workgroups required. Refer to
Screen 5-1 for an example. (Refer to the Multiple IP Subnetworks
section of Chapter 1 for further information.)
Note: Do not use the IP addresses shown in the examples as they should
follow your corporate IP address convention.
Screen 5-1: Configure IP Network Security Group – Example
Top>Config># ipas
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
IP ADDRESS CONFIGURATION MANAGEMENT FOR SLIP AND PPP SERVICES
1 Configure/Display IP Network Security Groups
2 Configure/Display Reserved IP Addresses
Enter Menu Selection
[ ? for help, q to quit, RETURN for menu ]
==> 1
IP NETWORK SECURITY GROUP MANAGEMENT FOR SLIP AND PPP SERVICES
1 Add an IP Network Security Group
2 Delete an IP Network Security Group
3 Edit an IP Network Security Group
4 Display all IP Network Security Groups
Enter Menu Selection
[ ? for help, q to quit, RETURN for menu ]
==> 1
Enter an IP Network Security Group name [q to quit, ? for help]
Screen 5-1: continued on next page
Issue 3 5-3
