Commander GP User Guide
Issue code: gpxu2
Programming Instructions A-3
A.6 Selecting
a parameter to access
If the display returns to Status mode during the
course of selecting parameters (because no keys
have been pressed for eight seconds), to re-enter
Parameter mode, press:
1. Momentarily press . The display enters
Parameter mode.
Parameter number 0.10, or the number of the
last selected parameter, appears on the lower
display. The value shown on the upper display
remains the same.
2. Within eight seconds, press
The parameter number decreases by one.
Repeat this step until 0.06 is displayed.
Notice that the upper display changes to show
the value of the parameter that is selected.
Scrolling
1. Within eight seconds, press and hold down:
The parameter number continuously increases
(scrolls upward) until the highest numbered
parameter in the menu is reached.
2. To start scrolling upward again from parameter
number 0.00, release then re-press:
3. Repeat steps 1 and 2 using
The parameter numbers will now decrease. In
step 2, when parameter 0.00 is reached,
releasing and re-pressing the key will re-start
downward scrolling from the highest numbered
parameter in the menu.
Quick selection of parameter 0.00
1. While the display is in Parameter mode, press at
the same time:
and
Parameter 0.00 is displayed.
2. Now select parameter number 0.06.
