Filter
Top Products
Global Settings: Chapter 8
QSR Reference Manual
MIDI O
UT
Page 12
The MIDI Out Mode determines whether the MIDI [OUTPUT] connector will
transmit MIDI information originating from the QSR (when set to “OUT”), or will
“echo” MIDI information that is received at the MIDI [INPUT] connector (when set to
“THRU”).
If the I/O parameter (see previous page) is set to either “Mac”, “PC 38.4kbaud” or
“PC31.25kbaud”, the MIDI Out parameter can only be set to “OFF” or “THRU”. This
is because unless the I/O parameter is set to “MIDI”, the MIDI [OUTPUT] connector
may only function as a MIDI “Thru” connector for the connected computer, and can
only be switched off.
M
IX
G
ROUP
C
HANNEL
Page 13
This determines which MIDI channel will play all those channels in the selected Mix
whose Group parameter is set to “On”. When in Mix Mode, you have the option to
transmit on several MIDI channels at once, or to temporarily isolate certain channels
within a Mix.
1–16. When the Group Mix Channel parameter is set between 1 and 16, the number it
is set to determines the single MIDI channel which, when MIDI information is
received on it, will play the channels in the selected Mix which have their Group
parameter turned on.
OFF. In this mode, the individual channels used by the selected Mix will only be
triggered by MIDI information received on its designated MIDI channel (Example: the
sound on channel 1 will only respond to information received on MIDI channel 1, the
sound on channel 2 will only respond to information received on MIDI channel 2,
etc.), regardless of whether each channel’s Group parameter has been turned on or
off. However, the MIDI In parameter for each channel must be turned on in order for
that channel to respond to incoming MIDI information on its own channel.
To turn on the Group function for a channel in a Mix:
➀ From Mix Play Mode, press [EDIT].
➁ Turn the [VALUE] knob clockwise until the KYBD/MIDI function appears.
➂ Press the [CURSOR
▲
] button once.
➃ Turn the [VALUE] knob clockwise until page 3 is displayed.
➄ Use the [
▲
MIDI
▲
] buttons to select one of the 16 channels in the Mix.
➅ Press the [CURSOR
▲
] button once.
➆ Turn the [VALUE] knob clockwise to turn on the Group parameter.