Filter
Top Products
Overview: Chapter 4
QSR Reference Manual 9
TO AUDITION PROGRAMS BEFORE STORING
To look for available memory locations to permanently store your Program into, you
can move between Program Mode and Mix Mode without losing your changes. This
is because Program Mode uses a Program edit buffer, and Mix Mode uses its own
Mix edit buffer along with 16 additional Program edit buffers. These buffers are
retained when moving between Program Mode and Mix Mode, making it easy to
search for a suitable location to store your newly created Program. Example: While in
Program Edit mode, go to Mix Mode and scroll through the Program list on one of
the Channels; while editing a Program from Mix Mode, go to Program Mode to scroll
through the Program list.
The way to tell the difference between a program edited in Program Mode and one
edited from Mix Mode is by looking at the lower-left corner of the display: in
Program Edit Mode, the words “
PROG EDITED” appear, while in Mix Edit Mode,
the words “
MIX PROG EDITED” appear.
You will lose your changes if you remain in the same mode and recall a different
Mix/Program by turning the [VALUE] knob.
To audition Programs before overwriting them with STORE
…when editing a Program in Program Mode:
➀ While in Program Edit mode, press [MIX].
This selects Mix Play Mode, retaining your edits to the Program in an edit buffer.
➁ Use the BANK SELECT [DOWN] and [UP] buttons select Preset Bank 1; then use
the [VALUE] knob to select Mix 99.
➂ Press both [
▲
MIDI CH
▲
] buttons simultaneously to select Channel 1.
➃ Use the BANK SELECT [DOWN] and [UP] buttons select the User Bank.
➄ Use the [VALUE] knob to go through the Programs in the User Bank until you
find one you wish to overwrite with the new edited Program. Take a note of the
number.
➅ Press [PROG] to enter Program Play Mode.
This recalls the edit buffer in Program Mode, which is your edited Program.
➆ Press [STORE].
The upper section of the display will read “
Save Program to USER xxx”
where XXX is a User Program number from 000 – 127.
➇ Use the [VALUE] knob to select the Program Number you noted in step 5.
➈ Press [STORE] again.
The Program is now stored.
✪