Filter
Top Products
• Click on the ‘OK’ button to start the test.
• Click on the ‘Cancel’ button to cancel the test.
Selecting ‘Start’ causes all microphones to be switched off, the current
speakers and request-to-speak lists to be cleared (where applicable) and all
microphone keys to become inoperative until testing has been completed.
The ‘Results’ text field will be also be cleared. If the noise generator is active,
the system will perform a test on every microphone that has been given a
seat number in the currently open installation file. The microphones will be
tested one by one, and a message will be displayed in the ‘Results’ text field
after each microphone has been tested. If the microphone is working prop-
erly, the following message is displayed:
‘Microphone <number> OK’
If the microphone is not working properly, the following message is
displayed:
‘Microphone <number> Faulty’
If you wish to temporarily stop testing:
• Click on the ‘Hold’ push button.
Testing will be suspended, but microphones remain off and the noise from
the noise generator will still be present. The ‘Results’ text field will display a
message for the unit currently being tested. The ‘Start’ push button
becomes a ‘Restart’ push button. The ‘Measure’ push button becomes
active. This allows you to re-test the microphone currently shown in the
‘Test’ field. To re-test:
• Click on the ‘Measure’ push button.
The microphone is tested again and the result is displayed in the ‘Results’
field.
If you wish to re-start testing:
• Click on the ‘Restart’ push button.
Testing will be re-started from the unit at which the testing was suspended.
Digital Congress Network Synoptic Microphone Control
Page 4-13 Software User Manual
CONTROLLING A CONFERENCE
4