Filter
Top Products
If you wish to stop testing completely:
• Click on the ‘Ok’ push button.
Testing will be stopped and the ‘Microphone Test’ dialogue box will
disappear. All activities suspended during testing will be resumed.
It is possible to start the test at a specific microphone, by specifying the
number of that microphone in the ‘Test’ edit field. To do so:
• Type the desired microphone number in the ‘Test’ edit field.
A microphone number consists of four alphanumeric characters (numbers
or letters).
You can also specify the microphone number by clicking on the up or down
scroll buttons situated to the right of the ‘Test’ text box.
Once you have specified the unit number at which the test is to begin:
• Click on the ‘Start’ push button.
The test will start at the specified microphone number and test all subse-
quent microphones in ascending numerical order.
It is also possible to disable the noise generator, which means the sound sig-
nal that is sent to system loudspeakers will be switched off (the default set-
ting is noise generator on). Disabling the noise generator allows manual
testing of microphones from the conference venue. To do so:
• Click on the ‘Off’ radio button beneath the ‘Noise Generator’ text.
NOTE: When the noise generator is disabled, no test results will be
displayed.
When you have finished microphone testing:
• Click on the ‘Ok’ push button.
The ‘Microphone Test’ dialogue box will disappear.
CONTROLLING A CONFERENCE
Synoptic Microphone Control Digital Congress Network
Software User Manual Page 4-14
4