Filter
Top Products
84
Chapter 15. Appendices
■ Channel Mode Message
● All Sound Off (Controller No.120)
Status Second Third
BnH 78H 00H
n = MIDI Channel Number: 00H - 0FH (ch.1 - ch.16)
* All Current active voice in the specified channel will be shut off.
■ System Common Message
● Song Position Pointer
If the system parameter “SYSTEM/UTILITY/MIDI” setting “MIDI Sync Mode” is set to
“MIDI/AUTO,” Song Position Pointer messages are received when stopped.
Status Second Third
F2H mmH nnH
nn, mm = Song Position Point: 00H 00H - 7FH 7FH
● Song Select
Status Second
F3H ssH
ss = Song Number: 00H-13H (0-19)
■ System Realtime Message
● Timing Clock
This message is received when the “MIDI Sync Mode” of the system parameter “SYSTEM/
UTILITY/MIDI” is set at “MIDI/AUTO”.
Status
F8H
● Start
This message is received when the “MIDI Sync Mode” of the system parameter “SYSTEM/
UTILITY/MIDI” is set at “MIDI/AUTO/REMOTE”.
Status
FAH
● Continue
This message is received when the “MIDI Sync Mode” of the system parameter “SYSTEM/
UTILITY/MIDI” is set at “MIDI/AUTO/REMOTE”.
Status
FBH
● Stop
This message is received when the “MIDI Sync Mode” of the system parameter “SYSTEM/
UTILITY/MIDI” is set at “MIDI/AUTO/REMOTE”.
Status
FCH
● Active Sensing
Status
FEH
* Whenever the SP-505 receives this message, it monitors the interval of the incoming
data.If the subsequent message has not arrived within about 400 ms after the previous
data it processes all tracks as though it has received All Sound Off, and mutes the
sounding voices, then stops monitoring receiving interval.
■ System Exclusive Message
Status Data Bytes Status
F0H iiH, ddH, ..., eeH F7H
Byte Description
F0H Status of System Exclusive Message
ddH Data: 00H - 7FH (0 - 127)
: :
eeH Data
F7H EOX (End of System Exclusive Message)
● Universal System Exclusive Message
❍ INQUIRY MESSAGE
Identity Request
Status Data Bytes Status
F0H 7EH, 7FH, 06H, 01H F7H
Byte Description
F0H Status of System Exclusive Message
7EH Universal System Exclusive Message Non Realtime Header
7FH Broadcast
06H General Information (sub-ID #1)
01H Identity Request (sub-ID #2)
F7H EOX (End of System Exclusive Message)
The message is used to request the particular information of the SP-505.
The SP-505 does not transmit the message.
If the SP-505 received the message, the SP-505 transmits the prescribed Identity Reply
message.
2. TRANSMITTED DATA
■ Channel Voice Message
● Note On/Off
Transmit the note on/off in the MIDI channel number which is designated with “Pads
Channel” or “Part1-4 Channel” in the system parameter “SYSTEM/UTILITY/MIDI”.
Status Second Third
9nH mmH llH
n = MIDI Channel Number: 00H - 0FH (ch.1 - ch.16)
mm = Note Number: 23H - 48H (35 - 72)
ll = Velocity: 01H - 7FH (1 - 127) / 00H = NOTE OFF
Pad bank (#1) receive note numbers 23H (35).
Pad Number Note Number
Pad EXT 35 (23H)
Pad banks (#1-12, #17-32) receive note numbers 23H-33H (35-51).
Pad Number Note Number
Pad 1 36 (24H) GS TONE KICK 1
Pad 2 37 (25H) GS TONE SIDE STICK
Pad 3 38 (26H) GS TONE SNARE 1
Pad 4 39 (27H) GS TONE HAND CLAP
Pad 5 40 (28H) GS TONE SNARE 2
Pad 6 41 (29H) GS TONE LOW TOM 2
Pad 7 42 (2AH) GS TONE CLOSED HH
Pad 8 43 (2BH) GS TONE LOW TOM 1
Pad 9 44 (2CH) GS TONE PEDAL HH
Pad 10 45 (2DH) GS TONE MID TOM 2
Pad 11 46 (2EH) GS TONE OPEN HH
Pad 12 47 (2FH) GS TONE MID TOM 1
Pad 13 48 (30H) GS TONE HI TOM 2
Pad 14 49 (31H) GS TONE CYMBAL
Pad 15 50 (32H) GS TONE HI TOM 1
Pad 16 51 (33H) GS TONE Ride Cymbal 1