Korg BX-3 Musical Instrument User Manual


 
Parameters
35
3.Use the [-][+] keys to select the power-on setting for
the upper DRAWBAR SELECT section.
PRESET: When the power is turned on, the [Preset
Drawbar] key will be recalled.
1: When the power is turned on, the [Drawbar 1] key
will be recalled.
2: When the power is turned on, the [Drawbar 2] key
will be recalled.
4.To specify the power-on setting for the lower DRAW-
BAR SELECT section, press the [ ®] key.
5.Use the [-][+] keys to select the power-on setting for
the lower DRAWBAR SELECT section.
6.Press the [WRITE/ENTER] key.
When the settings have been registered, the display
will indicate DfltDB Set Completed, and will then
indicate Default DB Select.
Exp Pdl Calibration (Expression Pedal Calibration)
If operating the expression pedal connected to the rear
panel EXPRESSION PEDAL jack does not produce the
appropriate result, use the following procedure to adjust
the sensitivity of the expression pedal.
1.Connect the expression pedal to the rear panel
EXPRESSION PEDAL jack.
2.Select this parameter.
3.Press the [WRITE/ENTER] key.
The display will indicate Set ExpPdl Min Pos.
4.Move the expression pedal to the minimum position,
and press the [WRITE/ENTER] key.
The display will indicate Set ExpPdl Max Pos.
5.Move the expression pedal to the maximum position,
and press the [WRITE/ENTER] key.
Wheel Brake ON
This simulates the way in which the tone wheel rotation
slows down when the power of a tone wheel organ is
switched on/off.
When you press the [WRITE/ENTER] key, the tone wheel
rotation will gradually slow down and stop. At this time,
the pitch will also fall. Press the [WRITE/ENTER] key
once again, and tone wheel rotation will gradually
resume.
Group 8: DEMO
DEMO Play [1...9]
Here you can select and play back the demo songs.
For details, refer to “1. Listening to the demo songs”
(p.11).