Filter
Top Products
43
5. Pattern mode
5. Pattern mode
Copying a part (COPY PART)
You can copy the sound settings and rhythm pattern data (includ-
ing motion sequence) from another part to the selected part.
1. If the pattern is playing, press the Stop/Cancel key to stop play-
back.
2. Press a part key to select the copy destination part (the key will
light).
3. Hold down the SHIFT key and press step key 5 (COPY PART).
(Key 5 will blink.) The display will begin blinking.
4. Rotate the dial to select the copy source pattern number.
5. Use the part keys to select the copy source part. (The copy source
key will blink, and the copy destination key will be dark.)
6. Press step key 5 once again to execute the Copy Part operation.
To cancel, press the Stop/Cancel key.
If a sample is copied to a monaural part, the sound and rhythm
pattern data will be copied. However if a sample is copied
from stereo sample part 1 or 3 to a monaural sample part,
the sound will not be copied.
The sound and rhythm pattern data of a sample part whose
sample is stereo can be copied only between sample parts
1 and 3.
For details on data copy within the same part, refer to the
following section "Data Copy within a part."
Convenient functions for
editing patterns
If you wish to save the pattern you edit using these functions,
you must perform the W rite operation before selecting a dif-
ferent pattern or turning of f the power .
Erasing rhythm pattern data from
a part
To erase the rhythm pattern data for the selected part, you can use
one of the following two methods in addition to turning each of
the sixteen step keys off.
• Erasing data during playback or
recording (ERASE)
1. Press a part key to select the part from which you wish to erase
data.
2. During playback or recording, hold down the SHIFT key and
press the Rec key. As long as you continue holding these keys,
data will be automatically be erased from the selected part.
• Erasing all data from a part
(CLEAR PART)
This operation erases all rhythm pattern and motion sequence data
at once.
1. If the pattern is playing, press the Stop/Cancel key to stop play-
back.
2. Press a part key to select the part whose data you wish to erase.
3. Hold down the SHIFT key and press step key 7 (CLEAR PART).
(Key 7 will blink.)
4. Once again press step key 7 to clear the data.
To cancel without clearing the data, press the Stop/Cancel key.