Korg ES-1 DJ Equipment User Manual


 
45
5. Pattern mode
5. Pattern mode
Editing motion sequence
data
You can edit the motion sequence of each part or the effect motion
sequence. The data can be edited in units of individual steps.
Selecting a motion sequence
MOTION DEST.
PCh (PITCH/SPEED)...ti
n
(TIME)
1. Select the pattern that contains the motion sequence data you
wish to edit.
2. Use the cursor keys [][] to make the parameter select LED
indicate MOTION DEST.
3. Rotate the dial to select the parameter that you wish to edit.
For PCh (PITCH/SPEED), LEU (LEVEL), FLt (FILTER), and PAn
(PAN), only one parameter is valid for each part.
EFF (EFFECT), roL (ROLL), and rEU (REVERSE) are valid for each
part.
Ed1 (EDIT 1), Ed2 (EDIT 2), dPt (DEPTH), and ti
n
(TIME) are valid
for the pattern (all parts).
1,3
2
Editing the parameter values of a
motion sequence
MOTION VALUE
PCh (PITCH/SPEED) dis, –64...63
LEU (LEVEL) dis, 0...127
FLt (FILTER) dis, 0...127
Pan (PAN) dis, L.64...r.63
EFF (EFFECT) dis, oFF...on
roL (ROLL) dis, oFF...on
rEU (REVERSE) dis, oFF...on
Ed1 (EDIT 1) dis, 0...127
Ed2 (EDIT 2) dis, 0...127
dPt (DEPTH) dis, 0...127
ti
n
(TIME) dis, 0...127
1. Use the cursor keys [][] to make the parameter select LED
indicate MOTION VALUE.
2. The display will alternately show the parameter name you se-
lected in the preceding “Selecting a motion sequence,” and the
value of the parameter.
3. Press a part key to select the part that you wish to edit.
4. Press a step key to select the step that you wish to edit. The
steps of a pattern whose length is two or greater can be selected
successively by pressing the SELECT key.
5. Rotate the dial to edit the parameter value at that step. If the
display indicates “diS,” the motion sequence does not apply to
that step.
1
3
5
4
For PITCH, FILTER, LEVEL, and PAN motion sequences,
using MOTION DEST . to change the parameter and editing
will cause all values to be initialized to “ diS.”
If you move to another pattern without writing the edited mo-
tion sequence, it will revert to the state of the original motion
sequence. If you wish to keep the edited motion sequence,
you must perform the W rite operation ( p.47 “Saving a pat-
tern”).
While editing a motion sequence, it is not possible to use the
step keys to switch steps on/of f.
Depending on the part, some parameters cannot be selected.
While recording a motion sequence, the display will indicate
rEC,” and it will not be possible to edit a motion sequence.
While editing a motion sequence, the Rec key has no ef fect.