Filter
Top Products
22
Turning the Power On/Off
941
Once the connections have been completed (p. 20), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
fig.power_e.eps
1. Verify the following before you turn on the power.
• The AC adaptor is correctly connected, or batteries are correctly installed.
• If using bus power, the SD-50 is correctly connected to the computer and the driver is installed.
• The peripheral devices are correctly connected.
• The volume of the SD-50 and of the connected equipment is minimized.
2. Set the [POWER] switch to DC IN/BATTERY.
If you’re using bus power, set the [POWER] switch to BUS.
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit
will operate normally.
3. Use the [VOLUME] dial to adjust the volume.
4. Adjust the volume of the connected equipment.
1. Minimize the volume of the SD-50 and the connected equipment.
2. Switch off the power on the connected audio equipment.
3. Turn the [POWER] switch OFF.
The display will go dark and the power will turn off.
Turning the Power On/Off
Turning the Power On
Turning the Power Off
[POWER] switch
[VOLUME] dial
SD-50_e.book 22 ページ ２０１０年１月２５日 月曜日 午前１０時５２分