Filter
Top Products
23
Before You Start Playing
Before You Start Playing
3.
Adjust the volume to an appropriate level by
moving the [Master Volume] slider or
operating the expression pedal.
Now adjust the [Master Volume] slider to a suitable
level. The volume will be increased when the Expression
Pedal is pressed down, and decreased when the pedal
is returned.
fig.00-28.eps
1.
Before switching the power off, set the [Master
Volume] slider to the Min (minimum) position.
2.
Press the [Power On] switch to turn off the
power.
fig. 00-27.eps,fig.00-27-2.eps
If you need to turn off the power completely, first turn off the
[POWER On] switch, then unplug the power cord from the
power outlet. Refer to “Power Supply” (p. 6).
The ATELIER features Phones jacks. These allow you to play
without having to worry about bothering others around you,
even at night.
fig.00-29.eps
1.
Connect your headphones to the [Phones] jack
underneath the left side of the keyboard.
The sound from the built-in speakers stops.
Now, sound is heard only through the headphones.
2.
Adjust the headphones volume with the
[Master Volume] slider and Expression pedal.
Some Notes on Using Headphones
fifig.00-31.eps
• To prevent damage to the cord, handle the headphones
only by the headset or the plug.
• Headphones may be damaged if the volume is too high
when they are plugged in. Lower the volume on the
ATELIER before plugging in headphones.
• To prevent possible auditory damage, loss of hearing, or
damage to the headphones, the headphones should not
be used at an excessively high volume. Use the
headphones at a moderate volume level.
• Accepts connection of Stereo headphones.
• If plugs of the headphones are plugged into the [Phones]
jack, no sound will be heard from the ATELIER’s
speakers.
Turning Off the Power
increase
the volume
decrease
the volume
increase
the volume
decrease
the volume
OFF
Upper position
NOTE
Using Headphones
AT-800_e.book 23 ページ ２００８年１０月１５日 水曜日 午前９時３７分