Filter
Top Products
117
Fixing the Pitch of Vocals (Pitch Correction)
Section 3
6. Use [CURSOR] to move the cursor to “Smth” and
specify the correction speed.
Smth (Smooth) -100–+100
The value set here is added to the value for the “Smooth”
patch parameter (p. 115).
When set to 0, the correction proceeds at the rate set in
the patch’s “Smooth” parameter.
The correction is performed more rapidly the lower the
value is compared to the value set for the patch, while
the correction is carried out more smoothly as the value
increases relative to the patch’s value.
Make this setting so that the sum is in the range from 0 to
100. No effect is achieved if the resulting value is lower than
0 or greater than 100.
7. Use [CURSOR] to move the cursor to “INSERT” and
press [ENTER].
Another new correction event is inserted.
8. Use [CURSOR] to move the cursor to “TIME” and
specify the time at which you want the correction to
end with the TIME/VALUE dial.
fig.03-368d
9. Use [CURSOR] to move the cursor to “NOTE” and
specify “OFF.”
10. Have the Recorder play the song from the beginning.
The correction is first applied at the point in the song
specified in Step 4, with the correction ending at the
point specified in Step 8.
11. To delete any unnecessary correction events, move the
cursor to the event and press [DELETE/MUTE].
The correction event is deleted.
You cannot delete the correction event at the beginning of the
song. If this correction event is unneeded, rather than
deleting it, just set the function to “OFF.”
12. Repeat Steps 3–11 as needed to specify the edited
range.
13. After you have completed entering the settings, press
[EXIT] repeatedly to return to the Play screen.
You can only save a Correction Event Map to a single song.
Even if you switch the patch with the pitch correction, the
Correction Event Map remains unchanged.
Time
Smth
(Correction Speed)
Note