Filter
Top Products
Installation
14
By using the Roland APC-33 all-purpose clamp (sold separately) in conjunction with the included mounting bracket, you can freely attach
the M-48 to any part of a mic stand.
•
APC-33 attachment screws x 4 (included)
•
Screws for fastening the M-48 x 2 (included)
1
Using the four included APC-33 attachment screws,
attach the APC-33 stand holder to the mounting bracket.
You must use the APC-33 attachment screws that were included
with the M-48. The M-48 may be damaged if you use the screws
included with the APC-33.
2
Attach the APC-33 to your mic stand or drum, and fasten
the mounting bracket.
3
Insert the hooks located on the M-48’s bottom panel into
the slits of the mounting bracket.
4
To more permanently secure the M-48 to the mounting
bracket, fasten with the two included screws as shown
below.
Attaching the M-48 to Any Part of a Mic Stand
Items to use
Stand holder
Mounting bracket
Hooks
(on the bottom panel)
Be careful not to pinch your hand when attaching the M-48 to the mounting bracket. Doing so may cause personal injury.
M-48_e.book 14 ページ ２００９年２月２４日 火曜日 午前９時３３分